Tenting

If your Cyboard is tenting-compatible, it will have several M4 holes in the bottom.

Each tenting leg should be assembled as follows:

1. screw the rubber foot onto the threaded rod of your chosen length
2. add 2 of the knurled nuts onto the other end of the threaded rod

In order to adjust the keyboard:

1. screw the legs into the bottom of the keyboard, adjusting the lengths until you reach the desired angle.
2. once you have everything in place, you can screw both nuts against the base plate.

Why 2 nuts?

by tightening 2 nuts against the bottom of the plate, they also tighten against each other. This allows you to remove the leg, but keep the nuts locked in place, allowing you to save your configuration even if you remove the legs.